Install Outer Rear Wheel Well - Ar63.10-P-0670-06SR

Model 453.3/4 

The following operation steps are shown on the left side of the vehicle on model 453.3 and must be performed on the right side in the same way in the event of damage.

1. Install outer rear wheel well (1), fit and fix in place.
2. Drill 6.7 mm rivet holes on outer rear wheel well (1) (areas C, D and E).
3. Remove outer rear wheel well (1).
4. Deburr rivet holes on outer rear wheel well (1) and body on both sides.
5. Remove grinding dust and drill chips.
6. Coat insides of spot weld flanges with zinc dust paint.
7. Install outer rear wheel well (1), fit and fix in place.
8. Rivet outer rear wheel well (1) with 6.5x12.5 blind rivets (areas C, D and E).
   Fig 1: Outer Rear Wheel Well Blind Rivet Locations

   Courtesy of MERCEDES-BENZ USA
9. Outer rear wheel well (1) (areas F, G and H).