Remove/Install Wind Deflector - AR77.25-P-1000MCO
MODEL 451.4, 453.4
Shown on model 451.4
| Remove | |||
| 1 |
Heat wind deflector (1) with heat gun and remove 000 588 00 84 00 Heat gun |
WS54.00-P-0049B | |
| Clean | |||
| 2 | Clean bonding surfaces | The bonding surface must be free of dust and grease. Otherwise the adhesive force of the glue starts to decrease. |
|
| Install | |||
| 3 | Mark installation position of wind deflector (1) with adhesive tape | Dimensions: A = 60 mm B = 445 mm Dimensions: A = 110 mm B = 445 mm |
|
| 4 | Remove protective foil and glue on wind deflector (1) according to markings | Do not touch adhesive or reposition wind deflector (1) after gluing on. Otherwise the adhesive force of the glue starts to decrease. |
|
| 5 | Remove tape |