Check And Correct The Adjustment Of The Headlamps - AP82.10-P-8260SR
MODEL 453
Halogen headlamps
| Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | AS00.00-Z-0005-01A | |
| General information on checking/correcting headlamp adjustment | AH82.10-P-1000-01A | ||
| Check | |||
| 1 | Check low beam setting and adjust if necessary | MODEL 453 Halogen headlamp ECE version | AP82.10-P-8263X |
| MODEL 453 Halogen headlamp SAE version Before the low beams are checked and set, all operation steps listed in the linked description must be performed carefully. Otherwise it cannot be guaranteed that the headlamps concerned are correctly set, which can then jeopardize the road safety of the vehicle! |
AP82.10-P-8263SR | ||
| 2 | Switch on high beam | ||
| 3 | Check setting of high beam | The high beams are adjusted when the corresponding low beams are adjusted and cannot be adjusted separately. If the high beam setting is not OK: ↓ Rectify the problem subject to a separate repair order. |
AP82.10-P-8260-02SR |
| 4 | Check front fog light setting and adjust if necessary | AP82.10-P-8265A | |
| 5 | Reset switch positions and, if necessary, load condition of vehicle to initial condition |