Install Armrest On Center Console - AN68.20-P-0001-01SR

MODEL 453.3## ## as of 004524, 453.4 with CODE J58 (Center console with drawer) 

1. Fold up trunk floor covering.
2. Insert captive nuts (3) into mounts in body and turn 90° clockwise.

   Ensure that captive nuts (3) are seated correctly.

   Courtesy of MERCEDES-BENZ USA

   Otherwise they can loosen during assembly or later.

3. Position bracket (4) on body.

   The drill holes (4) must be flush with the threads of the captive nuts in the side area, in the rear area the bracket (4) should cover the grub screw.

4. Screw on nut (5) up to limit stop.
5. Screw in bolts (6) up to limit stop.
6. Tighten nut (5).
7. Tighten bolts (6).
8. Fold trunk floor covering and fasten.

   Courtesy of MERCEDES-BENZ USA

9. Model 453.3## ## as of 004524, 453.4

   with code 535 (smart Media system)

   with code J58 (Center console with drawer)

   Model 453.3## ## as of 004524, 453.4

   with code 556 (Radio 56A MM2012 with DAB and PREMIUM SOUND)

   with code J58 (Center console with drawer)

   Model 453.3## ## as of 004524, 453.4

   with code 557 (RADIO 57A MM2012 without DAB)

   with code J58 (Center console with drawer)

   Model 453.3## ## as of 004524, 453.4

   with code 558 (smart Media system with DAB)

   with code J58 (Center console with drawer)

   Route electrical lines (7) with 4-pin white coupling and USB mini B connector from inside through rectangular cutout in armrest (1).

10. Route electrical line (8) with 2-pin black coupling from inside through round cutout in armrest (1).
11. Install armrest (1) on previously installed bracket (4).

    The side cutouts must be flush with the holes (arrows) in the bracket (4).

    Courtesy of MERCEDES-BENZ USA

12. Align armrest (1) and tighten thread rolling screws (9).

    The armrest (1) must be flush up to the center console.

    Courtesy of MERCEDES-BENZ USA

13. Install right and left cover (10) on armrest (1).

Courtesy of MERCEDES-BENZ USA