LEMON Manuals: Even more car manuals for everyone
Home >> Smart >> 2017 >> Fortwo Electric Drive, 2D Convertible >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Electrical System, Equipment & Instruments - 453 Chassis - 2 Of 3 >> Testing & Repair >> Disconnect/Connect Battery Ground Line - AR54.10-P-0003SR

Disconnect/Connect Battery Ground Line - AR54.10-P-0003SR

MODEL 453 

MODIFICATION NOTES

25.04.2017 Disconnect diagnostic system, added. Operation step 2  
G12093947Courtesy of MERCEDES-BENZ USA
WARNING Risk of injury  caused by caustic burns to eyes, skin and mucous membranes from battery electrolyte or due to short circuit. Risk of burn injuries  due to thermal changes. Risk of poisoning  from swallowing battery electrolyte. Wear protective gloves, protective clothing and safety glasses. In the event of escaping battery electrolyte, battery vapors, battery mist, smoke or heat development, secure the area, leave it and alert the fire department. AS54.10-Z-0001-04A 
  Risk of explosion  from explosive gas. Risk of poisoning and caustic burns  from swallowing battery electrolyte. Risk of injury  through burns to skin and eyes from battery acid or when handling damaged lead-acid batteries No fires, sparks, open flames or smoking. Wear acid-resistant gloves, clothing and glasses. Only pour battery acid into suitable and appropriately marked containers. AS54.10-Z-0001-01A 
  Notes on battery   AH54.10-P-0001-01A
  Disconnect, connect     
1 Detach high-voltage charging cable on both sides Model 453.09/39/49
If high-voltage charging cable is connected.
 
2 Switch off ignition and remove key from ignition lock NOTES
All electrical consumers must be switched off. They may otherwise be damaged when the negative terminal (1) is disconnected/connected.
 
3 Disconnect diagnostic system If diagnostic system is connected.  
4 Close doors IMPORTANT Wait until the daytime running lamps have gone out.  
5 Open maintenance flap    
6 Loosen negative terminal (1) and remove from on-board electrical system battery (G1) TORQUE SPECIFICATION Nut, battery cable to negative terminal/positive terminal of on-board electrical system battery *BA54.10-P-1007-01I 
7 Connect in the reverse order    
8 Reset clock IMPORTANT See Owner's Manual.  
BATTERY

Number Designation Model 453
BA54.10-P-1007-01I Nut, battery cable to negative terminal/positive terminal of on-board electrical system battery Nm 8