Check Setting Of High Beam - AP82.10-P-8260-02SR
MODEL 453
 Courtesy of MERCEDES-BENZ USA
|
The high beams are adjusted when the corresponding low beams are adjusted and may not be adjusted separately.
- Position the headlamp aimer (01) in front of the left or right high beam
- Check setting of high beam
Do not
perform corrections at the height adjustment screw (H) and side adjustment screw (S) of the corresponding headlamp.
Otherwise, the left or right low beam will be misaligned
The center of the light beam must be positioned on the central mark (1) in the headlamp aimer (01).
If the high beam setting is not OK:
Rectify the problem subject to a separate repair order.