Remove/Install Oil Feed Line For Turbocharger - AR09.40-P-6022SR
ENGINE 281.910 in MODEL 453
| Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | AS00.00-Z-0010-01A | |
| Risk of injury . Skin or eye injuries may result when handling hot or glowing objects. | Wear protective gloves, protective clothing and safety glasses, if necessary. | AS00.00-Z-0002-01A | |
| Remove/install | |||
| 1 | Remove heat shield over the CAT | AR49.10-P-6905SR | |
| 2 | Remove banjo bolt (2) | *BA09.40-P-1002-02A | |
| 3 | Remove screw/bolt (3) | ||
| 4 | Lower vehicle with vehicle lift | ||
| 5 | Remove banjo bolt (4) | *BA09.40-P-1003-02A | |
| 6 | Remove oil feed line (1) upwards | ||
| 7 | Install in the reverse order | ||
| Check | |||
| 8 |
Check engine oil level | AP18.00-P-0101S | |
| Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | AS00.00-Z-0005-01A | |
| 9 | Carry out engine test run and check engine for leaktightness around the oil feed line (1) |
EXHAUST GAS TURBOCHARGER
| Number | Designation | ENGINE 281.910 | |
|---|---|---|---|
| BA09.40-P-1002-02A | Banjo bolt, oil feed line to cylinder head | Nm | 40 |
EXHAUST GAS TURBOCHARGER
| Number | Designation | ENGINE 281.910 | |
|---|---|---|---|
| BA09.40-P-1003-02A | Banjo bolt, oil feed line to exhaust gas turbocharger | Nm | 12 |