Remove/install car2go wiring harness - AR54.18-P-0200MCG
MODEL 451.3 with CODE (P02) car2go
with instrument panel up to production date 30.8.10
| Remove/install | |||
| 1 | Remove card reader from windshield | AR54.30-P-2000MCG | |
| 2 | Remove smart car2go radio | * not for USA | AR82.60-P-7502MCC |
| * for USA only | AR82.60-P-7502MCU | ||
| 3 | Disconnect car2go electrical wiring harness (1) from vehicle wiring harness | ||
| 4 | Release SAM control unit and let hang with connected lines | * not for USA | AR54.21-P-1254MCC |
| * for USA only | AR54.21-P-1254MCU | ||
| 5 | Disconnect car2go electrical connector (2) | ||
| 6 | Guide car2go electrical wiring harness (1) out between A-pillar and instrument panel and expose | ||
| 7 | Remove car2go electrical wiring harness (1) | ||
| 8 | Install in the reverse order |