Remove/install drive shaft radial shaft sealing ring - AR26.40-P-0335MCC

TRANSMISSION 717.48 in MODEL 451.3/4 

Fig 1: Identifying Radial Shaft Sealing Ring Remove/Install Components

Courtesy of MERCEDES-BENZ USA

	Remove
1	Remove central clutch release bearing	Remove/install central clutch operator	AR25.20-P-0180MCC
2	Remove radial shaft sealing ring (2) using corresponding tool from transmission housing front section (1)	Guide tool between drive shaft and radial shaft sealing ring (2), twist and pull out of transmission housing front section (1) Removal and installation tool	Fig 3
	Install
3	Knock radial shaft sealing ring (2) all the way into front section of transmission housing (1) using drift	Moisten the sealing lip of the new radial shaft sealing ring (2) with transmission oil. Drift	Fig 2
4	Install central clutch release bearing	Remove/install central clutch operator	AR25.20-P-0180MCC

Fig 2: Identifying Drift (454 589 02 15 00)

Courtesy of MERCEDES-BENZ USA

Fig 3: Identifying Removal And Installation Tool (116 589 01 62 00)

Courtesy of MERCEDES-BENZ USA