Clutch actuator remove/install - AR25.20-P-0125MCU
MODEL 451.3/4 with ENGINE 132.910 with TRANSMISSION 717.4
MODIFICATION NOTES
| 19.3.09 | Document revised as per new repair method. The clutch motor can be replaced individually in the event of damage. |
| Removing | |||
| Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer. | AS00.00-Z-0010-01A | |
| 1 | Raise vehicle with vehicle lift | ||
| 2 | Disconnect electrical connector (2) on clutch motor (M18) | ||
| 3 | Remove bolts (3) and remove clutch actuator (1) from transmission | ||
| 4 | Remove bolts (4) and remove clutch motor (M18) from clutch actuator (1). | ||
| Install | |||
| 5 | Position clutch motor (M18) in clutch actuator (1) as per picture (arrow B) screw on with bolts (4) | *BA25.20-P-1004-01C | |
| 6 | Position clutch actuator (1) on transmission and fix in place with bolts (3) | ||
| 7 | Slide clutch actuator (1) towards the bell housing until the plunger of clutch actuator (1) abuts the release lever of the clutch operator | ||
| 8 | Starting from this position, slide the clutch actuator (1) by a further three graduation lines (arrow A) towards the bell housing and tighten bolts (3) | *BA25.20-P-1003-01C | |
| 9 | Contact electrical connector (2) on clutch motor (M18) | ||
| 10 | Lower vehicle with vehicle lift | ||
| 11 | Perform commissioning without control unit replacement | ||
| Connect STAR DIAGNOSIS and read out fault memory | AD00.00-P-2000-04MCC |
CLUTCH OPERATING MECHANISM
| Number | Designation | Model 451.3/4 | |
|---|---|---|---|
| BA25.20-P-1003-01C | Clutch actuator to transmission | Nm | 10 |
| BA25.20-P-1004-01C | Clutch motor to clutch actuator | Nm | 9 |