Retrofit front seat arm rest - AN91.27-P-0001MCC
MODEL 451.3/4 as of 30.9.09
| Removing | |||
| 1 | Remove driver seat (2) | * not for USA | AR91.10-P-1000MCC |
| * for USA only | AR91.10-P-1010MCU | ||
| 2 | Carefully cut off net at backrest cover (3) with sharp knife directly at the seam | On vehicles as of 31.8.10. |
|
| 3 | Remove backrest cover (3) until bracket (5) can be inserted at the right in backrest frame (6) | * not for USA |
AR91.10-P-8656MCC |
| * for USA only | AR91.10-P-8656MCU | ||
| 4 | Loosen nut (4) for sidebag unit | For code (I53) Head/thorax bag | |
| 5 | Remove cable ties (7) | ||
| Install | |||
| 6 | Lift off foam part (8) from backrest frame (6) and insert bracket (5) into the planned holes | ||
| 7 | Screw in bolts (9) | ||
| 8 | Attach new cable tie (7) where the lines are routed | ||
| 9 | Lay foam part (8) over the bracket (5) and cut out a passage for the bracket (5) in the foam part (8); position foam part (8) | ||
| 10 | Tighten nut (4) of sidebag unit | For code (I53) Head/thorax bag |
*BA91.60-P-1007-01C |
| 11 | Install backrest cover (3) | * not for USA | AR91.10-P-8656MCC |
| * for USA only For vehicles with code (I53) Head/thoraxbag, continue to tighten the nuts (4) on the sidebag unit. |
AR91.10-P-8656MCU | ||
| 12 | Mark position of the bracket (5) on the backrest cover (3) and make a cut out in the backrest cover (3) (arrows A) | ||
| 13 | Fold flaps so made on the backrest cover (3) inwards and pull backrest cover (3) over the bracket (5) | ||
| 14 | Place trim ring (10) on the bracket (5) | ||
| 15 | Push clamp (11) onto the bracket (5) and insert catch spring (12) | ||
| 16 | Insert armrest (1) into the bracket (5) in such a way that the chamfer (arrow B) points to the rear | ||
| 17 | Install driver seat (2) | * not for USA | AR91.10-P-1000MCC |
| * for USA only | AR91.10-P-1010MCU |
AIRBAG
| Number | Designation | Model 451.3 | Model 451.4 | |
|---|---|---|---|---|
| BA91.60-P-1007-01C | Nut, sidebag to backrest | Nm | 10 | 10 |