000 588 03 19 00 Load tester - WS15.00-P-0027B
WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2016 Mercedes-Benz E63 S AMG, 2016 Mercedes-Benz E400, 2016 Mercedes-Benz E350, 2016 Mercedes-Benz E300, and 2016 Mercedes-Benz E250. However, it is still accessible from the selected car via links, so may be relevant.
MODEL ALL
Use in FG 15/Set B
Purpose:
Load tester for loading the vehicle on-board network for the alternator charge current checking. Test equipment category CAT_B.
Procurement information:
This criteria catalogue serves to provide support for selection of variants of workshop equipment available on the free market. It just describes the minimum requirement for fulfilling the Mercedes-Benz standard. There is therefore no reference made to manufacturer specific equipment or devices.
NOTE:
These testers are not approved by Mercedes-Benz for obtaining findings on the starter battery.
Minimum requirements:
- The load tester is suitable for a direct voltage of up to 30 V.
- The load allows itself to be set steplessly or in steps of a maximum of 0.5 kW.
- The engageable load is at least 2.1 kW for a duty cycle of at least 15 seconds.
- The flow of current is interrupted during clamping on and disconnecting the tester on the on-board electrical system.
The usual designations for volt amp(s) tester on the free market include: load tester, Carbon Pile Load, battery tester or electronic load.