Remove/install stabilizer bar on rear axle - AR32.20-P-0315EW

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2016 Mercedes-Benz E63 S AMG, 2016 Mercedes-Benz E400, 2016 Mercedes-Benz E350, 2016 Mercedes-Benz E300, and 2016 Mercedes-Benz E250. However, it is still accessible from the selected car via links, so may be relevant.

MODEL 212, 218

Fig 1: Stabilizer Bar On Rear Axle Install/Remove Components

Courtesy of MERCEDES-BENZ USA

	Remove/install
	Risk of death caused by vehicle slipping or toppling off of the lifting platform.	Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer.	AS00.00-Z-0010-01A
	Notes on self-locking nuts and bolts		AH00.00-N-0001-01A
		While working on the rear axle care must be taken to ensure that the surface of all aluminum components do not get any scratches, cracks and notches. Otherwise the service life of the of the parts will be reduced.
1	Lower front rear axle carrier (1)		AR35.10-P-0015EW
2	Detach link rods (3) from torsion bar (4)		*BA32.20-P-1002-04N
3	Detach torsion bar (4) from rear axle carrier (1) and remove		*BA32.20-P-1003-04N
4	Install in the reverse order

REAR AXLE STABILIZER BAR

Number	Designation		Model 212	Model 218
BA32.20-P-1002-04N	Nut, link rod to stabilizer bar	Nm	50	40
BA32.20-P-1003-04N	Bolt, torsion bar to rear axle carrier	Nm	80	80