LEMON Manuals: Even more car manuals for everyone
Home >> Smart >> 2015 >> Fortwo Electric Drive, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Paintwork - 212 Chassis) >> Testing & Repair >> Care for lacquered surfaces - AR98.00-P-0011A

Care for lacquered surfaces - AR98.00-P-0011A

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2016 Mercedes-Benz E63 S AMG, 2016 Mercedes-Benz E400, 2016 Mercedes-Benz E350, 2016 Mercedes-Benz E300, and 2016 Mercedes-Benz E250. However, it is still accessible from the selected car via links, so may be relevant.

MODEL 117, 164, 166, 170, 171, 172, 176, 190, 197, 203, 204, 207, 209, 211, 212, 215, 216, 217, 218, 219, 220, 221, 222, 230, 231, 240, 242, 246, 251, 463 

With more scratch-resistant clear-coat system 

  Care     
1 Wash the vehicle    
2 Place polishing sponge exactly in the center on the backup pad IMPORTANT Before commencing the first polishing operation, slightly spray the polishing sponge using deionized water.
IMPORTANT Use commercially available polishing machine.		  
3 Apply a little polish to the paint or the polishing sponge IMPORTANT Shake bottle well before use.
Paint application/care		  
4 Polish the surfaces designated for treating NOTES Operate the polishing machine evenly. Otherwise visible irregularities are formed in the paint surface.
IMPORTANT Polish at the lowest rotational speed, approx. 800 RPM (1st stage), for 10 s with moderate pressure in cross-coat action at the area to be polished. Then increase rotational speed: 1300 RPM (3rd stage) to 1600 RPM (4th stage). Do not exceed a polishing time of 30 s at any one sanding spot.
IMPORTANT On larger areas, make sure that one partial area (approx. 1/4 m2 ) is always polished out at a time. Because the polish is ground while polishing, at the start a more abrasive effect is observed and the intensive gloss only appears at the end.
IMPORTANT Use commercially available polishing machine.
Paint application/care		  
5 Remove any polish residue IMPORTANT Spray on deionized water and then wipe with a microfiber cloth.
IMPORTANT Use commercially available tack rag.		  
6 Seal polishing mark Gloss preservation, 500 ml, DB supply specification 7551.10 *BR00.45-Z-1014-04A 
REPAIR MATERIALS

Number Designation Order number
BR00.45-Z-1014-04A Gloss preservation, 500 ml, DB supply specification 7551.10 A 000 986 44 74
scientia non olet · About LEMON Manuals