Remove/install control and operating unit - AR83.40-P-6350EW
WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2016 Mercedes-Benz E63 S AMG, 2016 Mercedes-Benz E400, 2016 Mercedes-Benz E350, 2016 Mercedes-Benz E300, and 2016 Mercedes-Benz E250. However, it is still accessible from the selected car via links, so may be relevant.
MODEL 212, 218
Front control and operating unit
Shown on model 212 with code (279) Electronic gear selector
| Remove/install | |||
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| 1 | Buffer the basic data of the automatic air conditioning control and operating unit (N22/7) in STAR DIAGNOSIS | When replacing the automatic air conditioning control and operating unit (N22/7). |
|
| Connect STAR DIAGNOSIS and read out fault memory | AD00.00-P-2000-04A | ||
| 2 | Move selector lever or gearshift lever to rearmost position | ||
| 3 | Switch off ignition | ||
| 4 | Unclip cover (1) from upper control panel control unit (N72/1) using extraction hook and remove | Fig 2 | |
| 5 | Cover up center console using a dry cloth (4) | ||
| 6 | Remove bolts (2) | ||
| 7 | Open lid (3) | ||
| 8 | Apply extraction hook at denoted areas (arrows), release AAC control and operating unit (N22/7) by pulling upwards and remove, until the electrical connectors (5) are accessible | Fig 2 | |
| 9 | Disconnect electrical connectors (5) | ||
| 10 | Install in the reverse order | ||
| 11 | Teach in and normalize the actuator motors | ||
| Connect STAR DIAGNOSIS and read out fault memory | AD00.00-P-2000-04A |