Remove contacts from FIN sensor contact coupling - AR00.19-P-0120-12A

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2016 Mercedes-Benz E63 S AMG, 2016 Mercedes-Benz E400, 2016 Mercedes-Benz E350, 2016 Mercedes-Benz E300, and 2016 Mercedes-Benz E250. However, it is still accessible from the selected car via links, so may be relevant.

MODEL ALL

Fig 1: Identifying Passenger Vehicle Wiring Harness Repair Kit (220 589 04 99 00)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Wiring Harness Repair Kit, Basic (000 589 13 99 00)

Courtesy of MERCEDES-BENZ USA

Fig 3: Identifying Blade Holder With Clamping Pliers (220 589 01 99 50)

Courtesy of MERCEDES-BENZ USA

Fig 4: Identifying LSK 8 Blade (220 589 01 99 56)

Courtesy of MERCEDES-BENZ USA

Unfasten secondary release on version with spring (shown on laminated sensor contact, Junior Power Timer coupling)

Insert a suitable tool between the spring and the housing.
Press out the spring.

Fig 5: Inserting Suitable Tool Between Spring And Housing
Courtesy of MERCEDES-BENZ USA

Unfasten secondary release on version with slide (shown on laminated sensor contact, Junior Power Timer coupling)
Push (1) slider out of locked position in direction of arrow.

Fig 6: Pushing Slider From Locked Position
Courtesy of MERCEDES-BENZ USA

Unfasten secondary release on version with pin
Using a suitable tool, push pin out of last detent in direction shown by arrow.

Fig 7: Pushing Pin Out From Last Detent Using Suitable Tool
Courtesy of MERCEDES-BENZ USA

Unpin female contacts from coupling
Insert blade holder with clamping pliers and LSK 8 blade from front side though openings at contact cavity of coupling (1).
This step compresses the spring shackles (2) on the female contact.
A slight tug on the corresponding cable will remove the female contact (1) from the coupling.

Fig 8: Removing Female Contact From Coupling
Courtesy of MERCEDES-BENZ USA