Tightening connecting rod bolts - AR03.10-P-6111-02AMG
WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2016 Mercedes-Benz E63 S AMG, 2016 Mercedes-Benz E400, 2016 Mercedes-Benz E350, 2016 Mercedes-Benz E300, and 2016 Mercedes-Benz E250. However, it is still accessible from the selected car via links, so may be relevant.
ENGINE 156
MODIFICATION NOTES
| 3.2.12 | Value modified: Connecting rod bearing cap on connecting rod, Stage 3 | *BA03.10-P-1001-01Q |
CONNECTING ROD
| Number | Designation | Engine 156 | ||
|---|---|---|---|---|
| BA03.10-P-1001-01Q | Connecting rod bearing cap on connecting rod | Stage 1 | Nm | 10 |
| Stage 2 | Nm | 40 | ||
| Stage 3 | ∠° | 90 | ||
Do not use impact wrench or compressed air tool to screw in otherwise the threaded holes will be damaged.
Connecting rod bolts must
be replaced.
The previously installed connecting rod bolts must not be used again otherwise loosening can occur and associated engine damage can occur.
- Lubricate the bolt thread and head contact surface with engine oil.
- Tighten connecting rod bolts.
Observe the tightening specification and tightening torque.
| Tightening specification | Stages (per connecting rod) | |
|---|---|---|
| 1 | Alternate tightening of connecting rod bolts | Stage 1 |
| 2 | Alternate further tightening of connecting rod bolts | Stage 2 |
| 3 | Alternate tightening of connecting rod bolts as per tightening angle | Stage 3 |
| 4 | Alternate loosening of connecting rod bolts | Stage 4 |
| 5 | Alternate tightening of connecting rod bolts | Stage 5 |
| 6 | Alternate further tightening of connecting rod bolts | Stage 6 |
| 7 | Alternate tightening of connecting rod bolts as per tightening angle | Stage 7 |