Removing and installing headlamp for daytime running light - AR82.10-P-2300EW
WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2016 Mercedes-Benz E63 S AMG, 2016 Mercedes-Benz E400, 2016 Mercedes-Benz E350, 2016 Mercedes-Benz E300, and 2016 Mercedes-Benz E250. However, it is still accessible from the selected car via links, so may be relevant.
MODEL 207 up to model year 2014
MODEL 212 (except 212.077/277) up to model year 2014
MODEL 218 up to model year 2015
Shown on right side of vehicle on MODEL 212 with CODE 622 (Intelligent Light System (right-hand traffic))
Shown on right side of vehicle on MODEL 212 except CODE 622 (Intelligent Light System (right-hand traffic))
Fig 2: Daytime Running Light Headlamp Remove/Install Components - Shown On Model 212 Except Code 622
| Remove/install | |||
| Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | AS00.00-Z-0010-01A | |
| 1 | Raise vehicle with vehicle lift | ||
| 2 | Loosen left and right fender liner in area of bumper (1) and lift out with assembly wedge until the left daytime running lights headlamp (E1/3) or right daytime running lights headlamp (E2/3) can be removed | Fig 3 | |
| 3 | Disconnect electrical connector (3) | ||
| 4 | Unscrew screws/bolts (4) and remove left daytime running lights headlamp (E1/3) or right daytime running lights headlamp (E2/3) from cover (2) | ||
| 5 | Install in the reverse order |