Remove/install taillamp - AR82.10-P-4905EW
WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2016 Mercedes-Benz E63 S AMG, 2016 Mercedes-Benz E400, 2016 Mercedes-Benz E350, 2016 Mercedes-Benz E300, and 2016 Mercedes-Benz E250. However, it is still accessible from the selected car via links, so may be relevant.
MODEL 212.0/1
MODEL 212.2
Shown on model 212.0
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Notes on sensor system for trunk lid opening/closing | AH80.61-P-0001-01A | ||
| Remove/install | |||
| 1 | Open left or right service flap (1) | ||
| 2 | Unhook bracket (7) from luggage net (8) from right side paneling (2) | MODEL 212.0/1 When removing right rear lamp unit (E4) |
|
| 3 | Lift right side paneling (2) to one side until nuts (4, 5, 6) are accessible | MODEL 212.0/1 When removing right rear lamp unit (E4) |
|
| 4 | Disconnect electrical connector (3) from left rear lamp unit (E3) or right rear lamp unit (E4) | MODEL 212.0/1 | |
| 5 | Detach soundproofing under left or right service flap (1) | MODEL 212.2 |
|
| 6 | Remove foam material above nut (4) and stop plug above nut (5) | MODEL 212.2 | |
| 7 | Unscrew nuts (4, 5, 6) |
|
|
| 8 | Detach left rear lamp unit (E3) or right rear lamp unit (E4) and disconnect electrical connector (3) | MODEL 212.2 | |
| 9 | Remove left rear lamp unit (E3) and right rear lamp unit (E4) | ||
| 10 | Install in the reverse order |