Remove/install tailgate wiper arm - AR82.30-P-6910CX

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2016 Mercedes-Benz E63 S AMG, 2016 Mercedes-Benz E400, 2016 Mercedes-Benz E350, 2016 Mercedes-Benz E300, and 2016 Mercedes-Benz E250. However, it is still accessible from the selected car via links, so may be relevant.

MODEL 204.2/9, 212.2

MODEL 218.9

Shown on model 204.2

Fig 1: Tailgate Wiper Arm Remove/Install Components - Shown On Model 204.2

Courtesy of MERCEDES-BENZ USA

	Remove/install
	Injury hazard from pinching and crushing, in extreme cases extremities can even be cut off when caught in windshield wiper mechanism.	Always remove ignition key when working on windshield wiper mechanism.	AS82.30-Z-0001-01A
1	Switch on ignition and move wiper arm (1) to park position
2	Switch off ignition and remove transmitter key or KEYLESS-GO start/stop button from electronic ignition lock control unit	KEYLESS-GO start/stop button only on vehicles with code (889) Keyless-Go.
3	Fold open cover (2)
4	Unscrew nut (3)	Wiper arm nut to rear-end door wiper motor	*BA82.30-P-1005-01M
5	Using the puller (4), detach the wiper arm (1) from the wiper shaft and remove	Attach wiper arm (1) to wiper shaft such that the wiper arm (1) is as horizontal and parallel to the lower edge of the window as possible.
		Puller	Fig 2
6	Install in the reverse order

WINDSHIELD WIPER

Number	Designation			MODEL 204	MODEL 212
BA82.30-P-1005-01M	Wiper arm nut to rear-end door wiper motor	Plastic	Nm	13	13
BA82.30-P-1005-01M	Wiper arm nut to rear-end door wiper motor	Metal	Nm	-	-

WINDSHIELD WIPER

Number	Designation			MODEL 218
BA82.30-P-1005-01M	Wiper arm nut to rear-end door wiper motor	Plastic	Nm	13
BA82.30-P-1005-01M	Wiper arm nut to rear-end door wiper motor	Metal	Nm	20

Fig 2: Identifying Puller (001 589 38 33 00)

Courtesy of MERCEDES-BENZ USA