Remove/install rain/light sensor - AR82.30-P-7800CW
WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2016 Mercedes-Benz E63 S AMG, 2016 Mercedes-Benz E400, 2016 Mercedes-Benz E350, 2016 Mercedes-Benz E300, and 2016 Mercedes-Benz E250. However, it is still accessible from the selected car via links, so may be relevant.
MODEL 166.0, 204, 207, 212, 218
Shown on model 204.0 with code (345) Rain sensor
| Remove/install | |||
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| 1 | Switch off ignition and remove transmitter key or KEYLESS-GO start/stop button from electronic ignition lock control unit | ||
| 2 | Swivel inside rearview mirror (A67) to one side | ||
| 3.1 | Unclip and remove cover (1) | Model 166.0, 204, 207.3, 212, 218, Model 207.4 without code (513) Speed Limit Assist or code (608) Automatic high beam recognition |
|
| 3.2 | Push cover (1) all the way forward and remove downward | Model 207.4 with code (513) Speed Limit Assist or code (608) Automatic high beam recognition |
|
| 4 | Remove splinter protection | Model 212 with code (Z04) Light armoring | |
| *BA63.20-P-1004-01B | |||
| 5 | Carefully push retaining clips (3) on both sides outwards in direction of the arrow and remove light sensor (B38/1) or rain/light sensor (B38/2) | ||
| 6 | Disconnect electrical connector (2) | ||
| 7 | Remove light sensor (B38/1) or rain/light sensor (B38/2) | ||
| 8 | Install in the reverse order | ||
| 9 | Select adaptation of rain sensor, light sensor amplification factor with coding, and windshield variant and enter or perform in vehicle with Star Diagnosis | When replacing light sensor (B38/1) or rain/light sensor (B38/2). |
AD00.00-P-2000-04A |
COLUMNS
| Number | Designation | Model 212 with code Z04 | |
|---|---|---|---|
| BA63.20-P-1004-01B | Nut/bolt, splinter guard to rain/light sensor guard plate | Nm | 12 |