Remove/install blocking circuit of rear window antenna - AR82.62-P-7200EW

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2016 Mercedes-Benz E63 S AMG, 2016 Mercedes-Benz E400, 2016 Mercedes-Benz E350, 2016 Mercedes-Benz E300, and 2016 Mercedes-Benz E250. However, it is still accessible from the selected car via links, so may be relevant.

MODEL 212.0/1

Fig 1: Rear Window Antenna Remove/Install Components

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Remove left and right upper C-pillar (1) and lay down to side with seat belt installed		AR68.30-P-4490EW
2	Fold foam material down to right side in area of C-pillar and disconnect electrical connectors (3)	When removing rear window interference suppression capacitor 2 (C3/2).
3	Disconnect electrical connectors (4) or electrical connectors (2) from rear window heater (R1)
4	Unclip rear window interference suppression capacitor 2 (C3/2) from body	When removing rear window interference suppression capacitor 2 (C3/2).
5	Remove ground line on rear window interference suppression capacitor 1 (C3/1) from left rear window heater ground point (W13/1) and remove rear window interference suppression capacitor 1 (C3/1)	When removing rear window interference suppression capacitor 1 (C3/1).
6	Remove ground line on rear window interference suppression capacitor 2 (C3/2) from right rear window heater ground point (W13/2) and remove rear window interference suppression capacitor 2 (C3/2)	When removing rear window interference suppression capacitor 2 (C3/2).
7	Install in the reverse order