Remove/install pressure transducer for boost pressure control - AR07.17-P-7002ELS
WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2016 Mercedes-Benz E63 S AMG, 2016 Mercedes-Benz E400, 2016 Mercedes-Benz E350, 2016 Mercedes-Benz E300, and 2016 Mercedes-Benz E250. However, it is still accessible from the selected car via links, so may be relevant.
ENGINE 276.8 in MODEL 207, 212, 218
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Notes on avoiding damage through contamination and foreign objects | AH00.00-P-5000-01A | ||
| Remove/install | |||
| 1 | Remove engine cover | ||
| 2 | Remove right engine air intake duct upstream of left air filter | ||
| 3 | Disconnect electrical connection (2) at boost pressure control pressure transducer (Y31/5) | ||
| 4 | Remove holder (3) from low-temperature circuit coolant expansion reservoir (1) | ||
| 5 | Mark vacuum hoses (4) relative to the respective connectors | ||
| 6 | Detach vacuum hose (4) from boost pressure control pressure transducer (Y31/5) | ||
| 7 | Remove screw/bolts (5) and take out boost pressure control pressure transducer (Y31/5) upwards | ||
| 8 | Install in the reverse order | ||
| 9 | Read out fault memory using the diagnostic system and clear if necessary | ||
| AD00.00-P-2000-04A |