Crank engine with starter - AR01.10-P-0110EL
WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2016 Mercedes-Benz E63 S AMG, 2016 Mercedes-Benz E400, 2016 Mercedes-Benz E350, 2016 Mercedes-Benz E300, and 2016 Mercedes-Benz E250. However, it is still accessible from the selected car via links, so may be relevant.
ENGINES 157, 276, 278 in MODEL 212, 218
| Remove/install | |||
| Risk of injury caused by fingers being pinched or crushed when removing, installing or aligning hoods, doors, trunk lids, liftgates or sliding roof | Keep body parts and limbs well clear of moving parts. | AS00.00-Z-0011-01A | |
| 1 | Bring transmission into neutral and switch off ignition | ||
| 2 | Unclip electrical line (1) from cover (2) and set aside | ||
| 3 | Remove cover (2) from front SAM control unit with fuse and relay module (N10/1) | ||
| 4 | Remove starter circuit 50 relay (N10/1kM) | ||
| 5 | Plug electrical feed line () of compression recorder into slot 87 (see arrow) | ||
| Figure | |||
| Figure | |||
| 6 | Attach electrical feed line for compression recorder to circuit 30 terminal point in engine compartment | ||
| 7 | Crank engine by pressing contact switch at compression recorder | ||
| 8 | Install in the reverse order |