Fasten boots with clamps - AR46.40-P-7200-01EW

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2016 Mercedes-Benz E63 S AMG, 2016 Mercedes-Benz E400, 2016 Mercedes-Benz E350, 2016 Mercedes-Benz E300, and 2016 Mercedes-Benz E250. However, it is still accessible from the selected car via links, so may be relevant.

MODEL 172, 204, 207, 212, 218

Fig 1: Rack-And-Pinion Steering Boot And Clamp

Courtesy of MERCEDES-BENZ USA

Position clamp (1).
Model 204, 207, 212, 218:

The clamp (1) for the boot (3) must be positioned as shown in the picture. Otherwise there will not be enough clearance with the front axle carrier when the rack-and-pinion steering is at an extreme angle (5).
Position clamp (2).
The clamps (2) for the boot (3) must be positioned as shown in the picture. Otherwise, the locking fins (4) of the clamp (2) will be pushed against the boot (3) in the case of extreme steering angles.
Secure clamps (1, 2).
Check that clamps (1, 2) are fitted securely and at correct position.