Remove/install charge air temperature sensor - AR09.41-P-2002OGE

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2016 Mercedes-Benz E63 S AMG, 2016 Mercedes-Benz E400, 2016 Mercedes-Benz E350, 2016 Mercedes-Benz E300, and 2016 Mercedes-Benz E250. However, it is still accessible from the selected car via links, so may be relevant.

ENGINE 642 in MODEL 207, 212

Fig 1: Charge Air Temperature Sensor Remove/Install Components

Courtesy of MERCEDES-BENZ USA

	Remove/install
	Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running	Secure vehicle to prevent it from moving by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts.	AS00.00-Z-0005-01A
1	Remove engine trim panel
2	Remove engine intake air duct upstream of air filter housing
3	Disconnect electrical connector from charge air temperature sensor (B17/8)	The electrical connector also, at the time, secures the snap-in bracket on the charge air temperature sensor (B17/8).
4	Unlock charge air temperature sensor (B17/8) on the support and remove from engine charge air duct downstream of charge air cooler (1)	Press snap-in bracket together, do not unlatch or latch charge air temperature sensor (B17/8) with the electrical connector so that the snap-in bracket is not overstretched. Always replace charge air temperature sensor (B17/8) with defective snap-in brackets. Replace seal ring.
5	Pull out charge air temperature sensor (B17/8)
6	Install in the reverse order