Test brake system with pressure tester for leaks - AR42.10-P-0015EW
WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2016 Mercedes-Benz E63 S AMG, 2016 Mercedes-Benz E400, 2016 Mercedes-Benz E350, 2016 Mercedes-Benz E300, and 2016 Mercedes-Benz E250. However, it is still accessible from the selected car via links, so may be relevant.
MODEL 207, 212, 218
MODIFICATION NOTES
| 4.6.13 | Bleed screw to brake caliper | MODEL 212 | BA42.10-P-1002-12J |
| 4.6.13 | Bleed screw to brake caliper | MODEL 207 | BA42.10-P-1002-12J |
| 4.6.13 | Bleed screw to brake caliper | MODEL 218 | BA42.10-P-1002-12J |
| Risk of poisoning from swallowing brake fluid. Risk of injury from skin and eye contact with brake fluid | Only pour brake fluid into suitable and appropriately marked containers. Wear protective clothing and eye protection when handling brake fluid. | AS42.50-Z-0001-01A | |
| Notes on repairs to brake system | AH42.00-P-0003-01A | ||
| Notes on externally invisible brake fluid loss | AH42.10-P-9406-02V | ||
| Brake fluid notes | AH42.50-P-0001-01A | ||
| Check | |||
| 1 | Deactivate easy entry/exit feature | With code 275 (Driver's seat, steering column and outside mirrors with memory) | |
| 2 | Open engine hood | MODEL 207, 212, 218 | |
| MODEL 207, 212 | AR88.40-P-1000EW | ||
| 3 | Connect filling unit to brake fluid expansion reservoir (1) | ||
| 000 588 01 82 00 Filling unit | WS25.00-P-0016B | ||
| 4 | Remove bleed screw from left front brake caliper (2) and connect test equipment (3) | ||
| 000 588 07 21 00 Test equipment | Test equipment (3) for hydraulic oil systems may not be used for systems with brake fluid. If the brake fluid is mixed with mineral oil this may lead to brake failure! Observe the manufacturer's operating instructions to avoid any incorrect operation and measurement errors. Otherwise, proper brake operation cannot be assured. |
WS42.00-P-0014B | |
| 5 | Vent test equipment (3) | ||
| 6 | Switch off filling unit and vent pressure | ||
| High-pressure test | |||
| Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | AS00.00-Z-0005-01A | |
| 7 | Allow the engine to run at moderate speed and release the accelerator pedal suddenly | ||
| 8 | Immediately press down brake pedal as far as possible and insert brake pedal jack (010) with adapter between brake pedal and driver seat | Protect the brake pedal and driver seat. The brake pedal and driver's seat may be damaged. |
|
| Fig 3 | |||
| Fig 2 | |||
| 9 | Read off and note brake pressure on high-pressure gauge of test equipment (3) | ||
| 10 | Read off and note brake pressure again after 5 minutes on the high-pressure gauge of the test equipment (3) | ||
| Low-pressure test | |||
| 11 | Switch off engine and remove brake pedal jack (010) with adapter | ||
| 12 | Push down brake pedal several times | ||
| 13 | Press down brake pedal as far as possible and insert brake pedal jack (010) with adapter between brake pedal and driver seat | Protect the brake pedal and driver seat. The brake pedal and driver's seat may be damaged. |
|
| Fig 3 | |||
| Fig 2 | |||
| 14 | Slowly turn back brake pedal jack (010) until the low-pressure gauge on the test equipment (3) displays a brake pressure of approx. 3 bar | ||
| 15 | Read off and note the brake pressure after 2 minutes on the low pressure gauge of the test equipment (3) | ||
| 16 | Remove brake pedal jack (010) and adapter | Fig 3 | |
| Fig 2 | |||
| 17 | Detach test equipment (3) and tighten bleed screw on brake caliper (2) | ||
| 000 588 07 21 00 Test equipment | WS42.00-P-0014B | ||
| *BA42.10-P-1003-10J | |||
| 18 | Bleed brake system | AR42.10-P-0010-02EW | |
MODEL 207, 212 with TRANSMISSION 711.6, 716.6 |
*BA25.20-P-1001-01B | ||
| *BA42.10-P-1002-12J | |||
| *BA42.10-P-1003-10J | |||
| 19 | Detach filling unit | ||
| 000 588 01 82 00 Filling unit | WS25.00-P-0016B | ||
| 20 | Correct fluid level in brake fluid expansion reservoir (1) | ||
| AP42.10-P-4210EW | |||
| 21 | Close engine hood | MODEL 207, 212, 218 | |
| MODEL 207, 212 | AR88.40-P-1000EW | ||
| 22 | Activate easy entry and exit feature | With code 275 (Driver's seat, steering column and outside mirrors with memory) |
CLUTCH OPERATING SYSTEM
| Number | Designation | TRANSMISSION 711.6 in MODEL 117, 156, 171, 172, 176, 203, 204, 207, 212, 242, 246 | TRANSMISSION 716.6 in MODEL 163, 170, 171, 202, 203, 204, 207, 208, 209, 210, 212, 230 | |
|---|---|---|---|---|
| BA25.20-P-1001-01B | Bleed screw to central clutch operator | Nm | 9 | 9 |
REAR AXLE BRAKE CALIPER
| Number | Designation | MODEL 212 | MODEL 207 | |
|---|---|---|---|---|
| BA42.10-P-1002-12J | Bleed screw to brake caliper | Nm | 18 | 18 |
REAR AXLE BRAKE CALIPER
| Number | Designation | MODEL 218 | |
|---|---|---|---|
| BA42.10-P-1002-12J | Bleed screw to brake caliper | Nm | 18 |
FRONT AXLE BRAKE CALIPER
| Number | Designation | MODEL 207 | MODEL 212 (except 212.061/074/075/076/077/092/274/275/27 6/277/292) | |
|---|---|---|---|---|
| BA42.10-P-1003-10J | Bleed screw at brake caliper | Nm | 18 | 18 |
FRONT AXLE BRAKE CALIPER
| Number | Designation | MODEL 212.061 | MODEL 212.074/075/076/077/274/275/276/277 except CODE B07, MODEL 212.092/292 | |
|---|---|---|---|---|
| BA42.10-P-1003-10J | Bleed screw at brake caliper | Nm | 18 | 18 |
FRONT AXLE BRAKE CALIPER
| Number | Designation | MODEL 212.074/075/076/077/274/275/276/277 with CODE B07 | MODEL 218 (except 218.374/375/376/392/974/975/976/992) | |
|---|---|---|---|---|
| BA42.10-P-1003-10J | Bleed screw at brake caliper | Nm | 18 | 18 |
FRONT AXLE BRAKE CALIPER
| Number | Designation | MODEL 218.374/375/376/974/975/976 except CODE B07, MODEL 218.392/992 | MODEL 218.374/375/376/974/975/976 with CODE B07 | |
|---|---|---|---|---|
| BA42.10-P-1003-10J | Bleed screw at brake caliper | Nm | 18 | 18 |