Install and weld in center roof paneling - AR65.10-P-1000-04EWB

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2016 Mercedes-Benz E63 S AMG, 2016 Mercedes-Benz E400, 2016 Mercedes-Benz E350, 2016 Mercedes-Benz E300, and 2016 Mercedes-Benz E250. However, it is still accessible from the selected car via links, so may be relevant.

MODEL 212.0 except CODE (413) Panoramic glass roof with top sliding roof except CODE (414) Power glass tilting/sliding roof

Fig 1: Identifying Set Of Spacer Blocks (216 589 02 23 00)

Courtesy of MERCEDES-BENZ USA

Install center roof paneling (1). Fit with set of spacer blocks and fix in place.
When removing, observe specified dimensions and position of set of spacer blocks.
Drill Ø 5.0 mm rivet holes in center roof paneling (1).
Drill rivet holes from bottom through spot welds predrilled during removal.
Remove center roof paneling (1) and set of spacer blocks.
Deburr rivet holes on center roof paneling (1) from both sides.

Fig 2: Center Roof Paneling Spacer Blocks
Courtesy of MERCEDES-BENZ USA
Apply 2-component adhesive in crosshatched areas.
Observe pretreatment of bonding surfaces.

Refer to the manufacturer's information for the curing and working times of 2-component adhesive.
Apply sealant to center roof bow.

Fig 3: Center Roof Bow Sealant Applying Area
Courtesy of MERCEDES-BENZ USA
Install center roof paneling (1), fit with set of spacer blocks and fix in place.
Rivet center roof paneling (1) with 4.8 8 steel/steel blind rivets (areas D and E).
Center roof paneling (1) (areas F and G).
Clean weld joints.
Remove drill shavings.

Fig 4: Center Roof Paneling Blind Rivet Punch Area
Courtesy of MERCEDES-BENZ USA