Adjust tilting/sliding roof panel - AR77.20-P-1100CW
WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2016 Mercedes-Benz E63 S AMG, 2016 Mercedes-Benz E400, 2016 Mercedes-Benz E350, 2016 Mercedes-Benz E300, and 2016 Mercedes-Benz E250. However, it is still accessible from the selected car via links, so may be relevant.
MODEL 204.0/2, 212, 218 with CODE 414 (Power glass tilting/sliding roof)
MODEL 205 with CODE 414 (Sliding sunroof)
Shown on model 204.0
| Remove | |||
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| 1 | Move tilting/sliding roof panel (1) into tilt position | ||
| 2 | Completely open sliding roof lining (2) | ||
| 3 | Remove left and right rubber bellows (3) | ||
| Adjust | |||
| 4 | Close tilting/sliding roof panel (1) | ||
| 5 | Loosen bolts (4) on left and right on tilting/sliding roof panel (1) | ||
| 6 | Guide cardboard strips (5) from rear center into sealing joint | ||
| 7 | Adjust tilting/sliding roof panel (1) in relation to roof paneling | ||
| Height setting | *BE77.20-P-1001-01H | ||
| 8 | Tighten bolts (4) on left and right on tilting/sliding roof panel (1) from rear toward front | ||
| Install | |||
| 9 | Move tilting/sliding roof panel (1) into tilt position | ||
| 10 | Install left and right rubber bellows (3) | ||
| 11 | Close tilting/sliding roof panel (1) | ||
| 12 | Close sliding roof lining (2) | ||
| 13 | Connect diagnostic system and perform teach-in run for anti-pinch protection of sliding roof | ||
| MODEL 205 with CODE 414 (Sliding sunroof) |
AD00.00-P-2000-04B | ||
| MODEL 204.0/2, 212, 218 with CODE 414 (Power glass tilting/sliding roof) |
AD00.00-P-2000-04A |
TEST AND ADJUSTMENT VALUES FOR TILTING/SLIDING ROOF
| Number | Designation | MODEL 204 | MODEL 205 | ||
|---|---|---|---|---|---|
| BE77.20-P-1001-01H | Height setting | Measuring position "A" (x) | mm | 140 | 140 |
| Front: Deeper than outer skin of roof | mm | 0...1 | 0...1 | ||
| Rear: Higher than outer skin of roof | mm | 0...1 | 0...1 | ||
TEST AND ADJUSTMENT VALUES FOR TILTING/SLIDING ROOF
| Number | Designation | MODEL 212 | MODEL 218 | ||
|---|---|---|---|---|---|
| BE77.20-P-1001-01H | Height setting | Measuring position "A" (x) | mm | 140 | 140 |
| Front: Deeper than outer skin of roof | mm | 0...1 | 0...1 | ||
| Rear: Higher than outer skin of roof | mm | 0...1 | 0...1 | ||