Disposing of shock absorber - OS32.25-P-0121-01GC
WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2019 Mercedes-Benz B250, 2018 Mercedes-Benz B250, 2017 Mercedes-Benz B250, 2016 Mercedes-Benz B250, and 2015 Mercedes-Benz SLK55 AMG. However, it is still accessible from the selected car via links, so may be relevant.
MODEL 168, 169, 171, 172, 176, 203, 204, 207, 209, 212, 218, 231, 245, 246, 414.700
- Drill out shock absorber tube, approx. 45 mm (dimension A) from the lower shock absorber eye, using a drill (5 mm dia.) (gas escapes).
- Push piston rod all the way in and pull out again.
- Remove protective tube from shock absorber.
- Drill a hole in the shock absorber tube approx. 30 mm (dimension B) away from the top edge of the tube using a 5 mm dia. drill bit.
- Pump the shock absorber empty by pushing in and pulling out the piston rod several times.
Observe regulations governing disposal of hydraulic fluid.
- Dispose of shock absorber (scrap).