LEMON Manuals: Even more car manuals for everyone
Home >> Smart >> 2015 >> Fortwo Electric Drive, 2D Convertible >> Repair and Diagnosis >> Engine Mechanical >> Lubrication System >> Engine Lubrication, Engine Oil Cooling - Maintenance >> Maintenance >> Check engine oil level with special tool >> Check engine oil level with special tool - AP18.00-P-1810MA

Check engine oil level with special tool - AP18.00-P-1810MA

ENGINE 112 

Fig 1: Checking Engine Oil Level (Engine 112)
G10037875Courtesy of MERCEDES-BENZ USA
DANGER Risk of accident  from vehicle starting off by itself when engine running. Risk of injury  (bruises and burns) resulting from working on the engine while it is being started or when it is running. Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. AS00.00-Z-0005-01A
DANGER Risk of injury  to skin and eyes due to handling of engine oil. Risk of poisoning  caused by swallowing engine oil Wear protective gloves, protective clothing and safety glasses.
Do not fill engine oil into beverage containers.
AS18.00-Z-0001-01A
1 Allow engine to warm up IMPORTANT Coolant temperature min. 80 °C.  
2 Turn off engine    
3 Pull stop plug (4) out of oil measuring pipe (5) IMPORTANT The stop plug (4) and oil measuring pipe (5) can be at the front or rear of the engine (depending on the model series).  
INSPECT Check     
4 Guide dipstick (04) into oil measuring pipe (5) IMPORTANT The tip of SPECIAL TOOL dipstick (04) must be in the oil pan.
The collar of the handle sits close to oil measuring pipe (5).
 
SPECIAL TOOL Measuring rod *120589072100
5 Read off engine oil level at dipstick (04) SPECIAL TOOL Measuring rod *120589072100
6 Determine level using oil level table FLUID SPECIFICATION
ENGINE 112.912/946 in MODEL 203
ENGINE 112.912/955 in MODEL 209
ENGINE 112.913/949 in MODEL 211
ENGINE 112.973 in MODEL 230
*BF18.00-P-1001-03B 
FLUID SPECIFICATION
ENGINE 112.916/953 in MODEL 203 with CODE M005 (4MATIC)
*BF18.00-P-1001-03K 
FLUID SPECIFICATION
ENGINE 112.917/954 in MODEL 211
ENGINE 112.975 in MODEL 220
*BF18.00-P-1001-03BM 
FLUID SPECIFICATION
ENGINE 112.961 in MODEL 203
*BF18.00-P-1001-03BA 
  If the engine oil level is too high or too low, correct it     
7 Correct the engine oil level not for USA
Maintenance intervals in combination with oils as per MBBV sheet, general overview
AP18.00-P-1849UB
Maintenance intervals in combination with oils as per MBBV sheet, general overview For USA only
IMPORTANT Check engine oil level again after correcting it. To do so repeat steps 4 through 6.
If engine oil level is too high,

Suction off engine oil quantity according to the oil level table.
If engine oil level is too low,

Fill engine oil quantity according to the oil level table.
AP18.00-P-1849UBU 
8 Insert stop plug (4) into oil measuring pipe (5)    
OIL LEVEL CHECK

Number Designation Engine 112.912/913/946/949/955/973
BF18.00-P-1001-03B Oil level Maximum mm 171
minimum mm 151
OIL LEVEL CHECK

Number Designation Engine 112.961 in model 203
BF18.00-P-1001-03BA Oil level Maximum mm 172
Minimum mm 152
OIL LEVEL CHECK

Number Designation ENGINE 112.917/954 in MODEL 211 with 4-MATIC ENGINE 112.975 in MODEL 220 with 4-MATIC
BF18.00-P-1001-03BM Oil level Maximum mm 125 125
Minimum mm 96 96
OIL LEVEL CHECK

Number Designation ENGINE 112.916/953 in MODEL 203 with 4MATIC
BF18.00-P-1001-03K Oil level Maximum mm 124
minimum mm 104
Fig 2: Identifying Measuring Rod (120 589 07 21 00)
G10037876Courtesy of MERCEDES-BENZ USA