Emergency release of charging cable plug at charger feed socket - AR54.10-P-5111MEX
MODEL 451.390/490
Fig 1: Identifying Rear CBS, Expansion Clips, Lever, Right Longitudinal Member Panel, Screws/Bolts And Charge Socket Flap CL (ZV) Motor
| Risk of death when touching components on vehicles with high-voltage on-board electrical system | Do not touch components and open lines of the high-voltage on-board electrical system. Persons who wear electronic implants (e.g. cardiac pacemakers), must not carry out any work on high-voltage on-board electrical systems. | AS54.00-Z-0001-01A | |
| Note on the high-voltage on-board electrical system | AH54.00-P-0010-01A | ||
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Evaluation of high-voltage components | AH54.00-P-6500-01SXH | ||
| Remove/install | |||
| 1 | Remove expansion clips (3) from right longitudinal member panel (2) | ||
| 2 | Unclip right longitudinal member panel (2) out of CBS rear end (1) | ||
| 3 | Remove screws/bolts (4) | ||
| 4 | Unclip right CBS rear end (1) (arrow) | ||
| 5 | Pull CBS rear end (1) out until the lever (5) is accessible | ||
| 6 | Disconnect charging cable connector on central locking motor charge socket flap (M14/11) with lever (5) | ||
| 7 | Install in the reverse order |