LEMON Manuals: Even more car manuals for everyone
Home >> Smart >> 2015 >> Fortwo Electric Drive, 2D Convertible >> Repair and Diagnosis >> Collision >> Paint & Coatings >> Paintwork - 451 Chassis >> Testing & Repair >> Paintwork bonding area for windshield - AR98.00-P-0900MCC

Paintwork bonding area for windshield - AR98.00-P-0900MCC

MODEL 451.3/4 

Shown on model 451.3 

Fig 1: Identifying Windshield Gluing Application Area On Body Flange
G10979206Courtesy of MERCEDES-BENZ USA
  Painting     
IMPORTANT Overview of smart materials and their use   AR98.00-P-0270MCC 
IMPORTANT Notes on repair paintwork in bonding area of windows and components   AH98.00-P-9408-07MCC
1 Mask interior compartment using adhesive tape    
2 Mask exterior area and remaining components using adhesive tape IMPORTANT On vehicles with previous body repairs, adapt the area covered to the repair performed.  
3 Sand down body flange (2) and bonding area for windshield (1) IMPORTANT Residual coating thickness approx. 20 μm.
In the bonding area for the windshield (1), sand the complete paintwork structure down to the coat of electrolytic immersion paint.
Grinding all the way down to the sheet steel are acceptable.
 
4 Completely clean area to be painted IMPORTANT The paint manufacturer's specifications must be complied with in full.  
5 Degrease area to be painted IMPORTANT The paint manufacturer's specifications must be complied with in full.
If glue is detached, repeat operation steps 1 and 2, if necessary.
 
6 Apply EP primer filler IMPORTANT Apply to the entire area to be painted. Use approved materials only. The paint manufacturer's specifications must be complied with in full.  
IMPORTANT General information on MB materials   AH98.00-P-9409-03SM
7 Mask bonding surface for windshield (1) IMPORTANT If necessary, remove any protruding markings. Use materials approved by the paint manufacturers only. AR98.00-P-0900-01MCC
      *BR00.45-Z-1134-02A 
8 Apply base coat and clear varnish of selected paint system IMPORTANT The paint manufacturer's specifications must be complied with in full.  
IMPORTANT General information on MB materials   AH98.00-P-9409-03SM
9 Perform over drying IMPORTANT The paint manufacturer's specifications must be complied with in full.  
NOTES Notes on force drying of vehicle paints   AH98.00-P-9408-03SM
10 Remove masking and bonding material    
REPAIR MATERIALS

Number Designation Order number
BR00.45-Z-1134-02A Tesa 7140 adhesive tape (12 mm) A 009 989 10 85