Install model designation on trunk lid - AR88.50-P-5050MCC

MODEL 451.3/4 

Fig 1: Identifying Model Designation, Carrier Foil And Protective Foil

Courtesy of MERCEDES-BENZ USA

Fig 2: Measuring Position Of Model Plate On Rear Wall Paneling

Courtesy of MERCEDES-BENZ USA

	Install
1	Clean mounting location on rear wall paneling (3) and degrease	The bonding surface must be absolutely free of dust and grease. Otherwise sufficient adhesion of model plate (1) is not ensured.
		Cleaner	*BR00.45-Z-1025-04A
2	Measure position of model plate (1) on rear wall paneling (3) and attach adhesive tape as marking.	The position is determined by the dimensions (a, b). To be measured from outside of rear wall paneling (3).
3	Remove protective foil (4)	Model plate (1) should remain fastened on carrier foil (2)
4	Align model plate (1) on attached adhesive plate and press on
5	Remove carrier foil (2) and adhesive tape

REPAIR MATERIALS

Number	Designation	Order number
BR00.45-Z-1025-04A	Cleaner	A 005 989 19 71