Remove/install washer fluid reservoir of windshield washer system - AR82.35-P-6000MCU

MODEL 451.3/4

Shown on model 451.3

Fig 1: Identifying Washer Fluid Reservoir Remove/Install Components

G10978969

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Remove front module		AR62.30-P-1575MCU
2	Suction off window washer fluid in washer fluid reservoir (1)
3	Unscrew nuts (2) from washer fluid reservoir (1)	Replace self-locking nuts (2).
4	Remove washer fluid reservoir (1) until windshield washer fluid pump (M5/1) is accessible
5	Unclip windshield washer fluid pump (M5/1) from washer fluid reservoir (1) and place to one side with connected hoses and the electrical line	Ensure that seal of windshield washer fluid pump (M5/1) is correctly seated on washer fluid reservoir (1).
6	Take off washer fluid reservoir (1)
7	Install in the reverse order
8	Fill washer fluid reservoir (1)
	Windshield washer system - inspect fluid level, adjust to correct level		AP82.35-P-8210MCC
9	Perform tightness check of washer fluid reservoir (1)
10	Perform function check of windshield washer system