Remove/install front CBS - AR88.00-P-1010MCC

MODEL 451.3/4 

Shown on model 451.3/4 up to 19.3.12 

Fig 1: Identifying Front CBS Remove/Install Components - Shown On Model 451.3/4 Up To 19.3.12 (1 Of 2)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Front CBS Remove/Install Components - Shown On Model 451.3/4 Up To 19.3.12 (2 Of 2)

Courtesy of MERCEDES-BENZ USA

Shown on model 451.3/4 as of 20.3.12 

Fig 3: Identifying Front CBS Remove/Install Components - Shown On Model 451.3/4 As Of 20.3.12

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Remove antenna rod
2	Remove additional turn signal lamps		AR82.25-P-4726MCC
3	Remove expansion clips (4) on left and right fender cover (3)	Open left and right door. On vehicles up to 30.8.10 press edge guard (5) to side in area of left and right fender cover (3).
4	Slightly slide left and right fender covering (3) upward and remove.
5	Unscrew bolts (6, 7)	Check whether guide sleeve on bolt (7) is seated correctly.
6	Unscrew bolts (2) from front CBS (1).
7	Remove longitudinal member panel (8).		AR88.80-P-6000MCC
8	Remove expansion clip (9) in area of left and right door hinge.
9	Unscrew bolts (10) located behind left and right longitudinal member panel (8) from front CBS (1).
10	Unscrew bolts (11) from front CBS (1).
11	Loosen catches (12) on CBS front end (1) and remove CBS front end (1) with aid of helper.	With code (V07) Front fog lamp (FFO), with code (V12) LED daytime running lights or daytime running lights "straight design", it is necessary to disconnect electrical connectors from front fog lamps and daytime running lights.
12	Install in the reverse order