Notes on no-load current consumption - AH54.10-P-0003-01TX
MODEL 219.3
Example of a measured curve of no-load current consumption
The following parameters are to be observed:
Measurement value < 40 mA:
This is the value that should be reached after 30 minutes at the latest.
Measurement value 1.2 A to 2.5 A:
No bus idle; one control unit keeps the entire Class B (interior)
Controller Area Network bus (CAN-B) "awake".
Measurement value 80 mA to 180 mA:
One control unit is not shutting down and this leads to an increased no-load current.
Another electrical or electronic component, e.g. a switch, could also cause increased no-load current consumption.