Retrofit car2go - AN82.00-P-0001CG

MODEL 451.3 (except 451.390) as of 31.8.10 with CODE (P02) car2go 

Shown with car2go components installed 

Fig 1: Identifying Car2Go Related Components (1 Of 2)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Car2Go Related Components (2 Of 2)

Courtesy of MERCEDES-BENZ USA

	Removing
1	Unclip and remove radio recess cover
2	Remove roof frame paneling (3) at front	* not for USA	AR68.30-P-4450MCC
		* for USA only	AR68.30-P-4450MCU
3	Remove left A-pillar trim	* for USA only	AR68.30-P-4050MCU
		* not for USA	AR68.30-P-4050MCC
4	Remove top part of dashboard	* for USA only	AR68.10-P-1020MCU
		* not for USA	AR68.10-P-1020MCC
	Install
5	Install rental car wiring harness (1)		AN82.00-P-0001-01CG
6	Install upper section of dashboard	Position card reader branch-off line (1.1) on instrument panel upper section.
		* for USA only	AR68.10-P-1020MCU
		* not for USA	AR68.10-P-1020MCC
7	Install left A-pillar trim	* for USA only	AR68.30-P-4050MCU
		* not for USA	AR68.30-P-4050MCC
8	Install roof frame paneling (3) at front	GSM antenna branch-off line (1.2) must run between hook (6) and spacer (5). Otherwise, GSM antenna branch-off line (1.2) will be damaged during assembly of roof frame paneling (3). * for USA only	AR68.30-P-4450MCU
		* not for USA	AR68.30-P-4450MCC
9	Fasten GSM antenna (4)		AN82.00-P-0001-04CG
		Primer	*BR00.45-Z-1038-02A
10	Install subscriber identification module (SIM) card of communication unit		AR82.85-P-2001MCG
11	Install smart radio car2go (A2/5)		AN82.00-P-0001-02CG
12	Install bracket (2) with card reader at windshield (A50/5)		AN82.00-P-0001-03CG
		Cleaner	*BR00.45-Z-1025-04A