Remove/install seat cushion cover - AR91.10-P-3312MCU
MODEL 451.3/4
Driver seat
Shown on code (S17) Seat heaters (FFO)
Fig 1: Identifying Seat Cushion Cover Remove/Install Components - Shown On Code (S17) Seat Heaters (FFO) (1 Of 2)
Fig 2: Identifying Seat Cushion Cover Remove/Install Components - Shown On Code (S17) Seat Heaters (FFO) (2 Of 2)
| Remove/install | |||
| Risk of injury caused by backrest suddenly folding forward if release lever is accidentally operated during inspection and repair work | When working on the seat, be careful not to accidentally release the backrest mechanism allowing the seat to fold forward. Keep body parts clear of the backrest travel area. | AS91.00-Z-0005-01V | |
| Risk of injury caused by performing testing or repair work on airbag or emergency tensioning retractor units. | Store airbag units with deployment side facing up; do not expose to temperatures greater than 100 °C. When working on these units, disconnect the power supply. | AS91.00-Z-0001-01A | |
| 1 | Remove driver seat | AR91.10-P-1010MCU | |
| 2 | Detach terminal strip (3) of seat cushion cover (1) in front and side area of seat console (2) | ||
| 3 | Place driver seat on a suitable surface on its side | ||
| 4 | Unclip plug (7) of wiring harness for seat heater (10) at seat console (2) | On vehicles with code (S17) Seat heaters (FFO) | |
| 5 | Unlock catch hook (12) and detach plug (7) from plug (11) | On vehicles with code (S17) Seat heaters (FFO) | |
| 6 | Unclip wiring harness for seat heater (10) from brackets (8) and detach connector of left heated seat cushion or right heated seat cushion | On vehicles with code (S17) Seat heaters (FFO) | |
| 7 | Remove cable ties (9) and expose seat heater (10) | On vehicles with code (S17) Seat heaters (FFO) | |
| 8 | Position extraction hook (6) at side on terminal strip (5) | Fig 3 | |
| 9 | Pull the extraction hook (6) towards the arrow, release the terminal strip (5) from the seat console (2) and completely expose it | Fig 3 | |
| 10 | Route terminal strip (5) of seat cushion cover (1) forwards between the seat cushion (4) and backrest | ||
| 11 | Place driver seat on its rails | ||
| 12 | Remove seat cushion (4) with seat cushion cover (1) from the seat console (2) | ||
| 13 | Fold seat cushion cover (1) in rear area as far forward as possible until the first Hog rings (15) are accessible | ||
| 14 | Remove hog rings (15) using suitable side cutting pliers | Align seams (14) of seat cushion cover (1) and position in the cutouts in the seat cushion (4). |
|
| Fig 4 | |||
| 15 | Remove seat cushion cover (1) | ||
| 16 | Install in the reverse order |