Remove/install vacuum pump - AR43.05-P-1320MEX
MODEL 451.390/392/490/492
| Risk of death when touching components on vehicles with high-voltage on-board electrical system | Do not touch components and open lines of the high-voltage on-board electrical system. Persons who wear electronic implants (e.g. cardiac pacemakers), must not carry out any work on high-voltage on-board electrical systems. | AS54.00-Z-0001-01A | |
| Note on the voltage on-board electrical system | AH54.00-P-0010-01A | ||
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Remove/install | |||
| 1 | Remove transmitter key and mains plug | ||
| Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | AS00.00-Z-0010-01A | |
| 2 | Raise vehicle with vehicle lift | ||
| 3 | Disconnect brake booster vacuum pump connector (M57x1) | ||
| 4 | Press both catch hooks (3) simultaneously in direction of arrow and pull brake booster vacuum line (1) off brake booster vacuum pump (M57) | ||
| 5 | Unscrew bolts (2) and remove brake booster vacuum pump (M57) | *BA43.05-P-1002-01E | |
| 6 | Install in the reverse order | ||
| 7 | Connect Star Diagnosis and check vacuum pump | ||
| AD00.00-P-2000-04MCC |
VACUUM PUMP
| Number | Designation | Model 451.390/391/392/49 0/491/492 | |
|---|---|---|---|
| BA43.05-P-1002-01E | Bolt, vacuum pump to bracket | Nm | 11 |