Install divider between luggage and passenger compartment - AZ68.50-P-0005MCC

MODEL 451.3 except CODE (P02) car2go 

Fig 1: Identifying Divider, Trunk Lining, Belt, Upper And Lower Anchorings

Courtesy of MERCEDES-BENZ USA

	Removing
1	Remove rear roof frame trim		AR68.30-P-4470MCC
	Install
2	Install lower anchorings (5) for divider (1) on vehicle floor		AZ68.50-P-0005-01MCC
			*BA68.50-P-1003-03D
3	Install upper anchorings (2) for divider (1) on roof frame		AZ68.50-P-0005-02MCC
			*BA68.50-P-1004-03D
		Graduated drill	Fig 2
		Twist drill bit set Rechargeable drill/screwdriver	Figure
4	Install rear roof frame trim		AR68.30-P-4470MCC
5	Hook divider (1) into upper anchorings (2)
6	Hook divider (1) into lower anchorings (5) and tension belts (4)
7	Insert divider (1) on left and right luggage compartment lining (3)
8	Add special equipment to the vehicle data card and to the online vehicle data card	Enter code (I05) Divider between luggage and passenger compartment.

CARGO RETAINER, DIVIDER

Number	Designation		Model 451.3
BA68.50-P-1003-03D	Bolt, divider bracket to vehicle floor	Nm	22
BA68.50-P-1004-03D	Bolt, divider bracket to rear roof frame	Nm	12

Fig 2: Identifying Graduated Drill (450 589 00 28 00)

Courtesy of MERCEDES-BENZ USA

Fig 3: Identifying Twist Drill Bit Set (450 589 01 70 00)

Courtesy of MERCEDES-BENZ USA