Notes on installing brake wear indicator contact sensors - AH42.10-P-0003-01RT
MODEL 251
- When replacing the brake pads the left front brake pad contact sensor (S10/1), right front brake pad brake pad contact sensor (S10/2) and right rear brake pad brake pad contact sensor (S10/4) must also be replaced.
- The left front brake pad contact sensor (S10/1), right front brake pad contact sensor (S10/2) and right rear brake pad contact sensor (S10/4) may only be mounted on the inner brake pads.
- The electrical feed line of the contact sensors must be routed as shown in the illustration.
- Check correct latching of left front brake pad contact sensor connector (S10/1x1), right front brake pad contact sensor connector (S10/2x1) and right rear brake pad contact sensor connector (S10/4x1).
Ingressing moisture can result in the warning lamp lighting up.