Risk of injury when performing check and repair work in area of roll bar - AS91.00-Z-0003-01QA

Before working in the area of the roll bar, pull out rear head restraints by hand. Keep body parts out of area where roll bar extends. 

MODEL 209.4 

Risk of injury 

When working in the area of the roll bar, serious injuries can occur due to sudden extension of the roll bar.

In particular the roll bar can be activated unintentionally while performing diagnostic and maintenance work on the control unit (N52) (the rollover sensors are integrated into the N52!).

It can also be triggered automatically within 1 h after "Ignition OFF". It is therefore not sufficient to only switch off the ignition.

Safety instructions/precautions 

• Monitor hazard area.
• Before working in the area of the roll bar, pull out the rear head restraints by hand, as the roll bars are located under the head restraints. When the roll bar is triggered, the rear seat head restraints extend another 10 cm as the roll bar moves upward at a very high speed!
• Keep body parts out of area where roll bar extends.