Remove/install brake line from the master brake cylinder to the ESP hydraulic unit - AR42.10-P-0034MCU
MODEL 451.3/4
| Remove/install | |||
| Risk of poisoning caused by swallowing brake fluid. Risk of injury caused by brake fluid coming into contact with skin and eyes. | Only pour brake fluid into suitable and appropriately marked containers. Wear protective clothing and eye protection when handling brake fluid. | AS42.50-Z-0001-01A | |
| Brake fluid notes | AH42.50-P-0001-01A | ||
| Notes on repairs to brake system | AH42.00-P-0003-01A | ||
| 1 | Remove brake lines from hydraulic unit (5) to rear axle | AR42.10-P-0035MCU | |
| 2 | Loosen nuts (2), remove bolts (3) and remove bracket (4) | *BA42.45-P-1008-01F | |
| 3 | Support hydraulic unit (5) using transmission jack and removal fixture and lower carefully until the brake lines (1) are accessible | Transmission jack |
Figure |
| 4 | Unclip retaining clip (7) of the electrical line (8) | Not on model 451.390/490 | |
| 5 | Check bolted connections of brake lines (1) with the hydraulic unit (5) and the master brake cylinder (9) for color coding | AR42.10-P-0013-05MCC | |
| 6 | Loosen bolted connections of brake lines (1) with the hydraulic unit (5) and the master brake cylinder (9) and separate | *BA42.10-P-1005-04E | |
| *BA42.10-P-1010-04E | |||
| 7 | Remove brake lines (1) | ||
| 8 | Install new brake lines (1) | Only if the brake lines (1) with the red color coding have been detached. | |
| 9 | Install in the reverse order | ||
| 10 | Bleed brake system | AR42.10-P-0010MCU |
BRAKE LINES, BRAKE HOSES
| Number | Designation | Model 451.3/4 | |
|---|---|---|---|
| BA42.10-P-1005-04E | Brake pipe to master brake cylinder | Nm | 16 |
| BA42.10-P-1010-04E | Brake line to ESP hydraulic unit | Nm | 16 |
ELECTRONIC STABILITY PROGRAM (ESP)
| Number | Designation | Model 451.3/4 | |
|---|---|---|---|
| BA42.45-P-1008-01F | Bolt, ESP hydraulic unit bracket to floor panel | Nm | 25 |