Retrofit BRABUS attachments on longitudinal member panel - AN88.85-P-1000MCC

MODEL 451.3/4 as of 20.3.12 

Standard longitudinal member panel 

Fig 1: Measuring Attachment Position Of BRABUS Attachments On Longitudinal Member Panel

Courtesy of MERCEDES-BENZ USA

Fig 2: Locating Adhesive Bead Applying Area On To Brabus Attachments In Crosshatched Area

Courtesy of MERCEDES-BENZ USA

Fig 3: Identifying Emblem And Protective Foil

Courtesy of MERCEDES-BENZ USA

	Install
	Risk of death  caused by vehicle slipping or toppling off of the lifting platform.	Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer.	AS00.00-Z-0010-01A
1	Raise vehicle with vehicle lift
2	Clean longitudinal member panel (2) and degrease	Silicone remover	*BR00.45-Z-1052-04A
3	Measure attachment position of BRABUS attachments (1) on longitudinal member panel (2) (dimensions a, b, c) and mark with adhesive tape or felt pen
4	Grind off paint residues at rear of BRABUS attachments (1) in crosshatched area
5	Clean rear of BRABUS attachments (1) and degrease	Silicone remover	*BR00.45-Z-1052-04A
6	Apply primer to BRABUS attachments (1) in crosshatched areas	The primer is included in the parts kit. Observe flash-off time for primer.
7	Apply Ø 8 mm adhesive bead (4) to BRABUS attachments (1) in crosshatched area	Cartridge heater   Cartridge gun   TS adhesive	*BR00.45-Z-1041-02B
8	Remove protective foil on adhesive tape (arrows) from BRABUS attachments (1)
9	Position BRABUS attachment (1) on longitudinal member panel (2) according to markings and press on	Aid of helper required.
10	Fix BRABUS attachment (1) in place on longitudinal member panel (2) with adhesive strips	The durability is reached after approx. 3 h measured from the time the BRABUS attachment (1) is installed.
11	Remove protective foil (5) from emblem (3)
12	Glue Emblem (3) to BRABUS attachment (1) in center	Previously clean bonding area on BRABUS attachment (1) and degrease. Silicone remover	*BR00.45-Z-1052-04A
13	After adhesive has dried remove strips of tape attached for arresting BRABUS (1) attachment
14	Enter retrofitted equipment in Vehicle Documentation (VeDoc)	Attach note "BRABUS attachments retrofitted according to AN88.85-P-1000MCC " to field organization texts .

REPAIR MATERIALS

Number	Designation	Order number
BR00.45-Z-1041-02B	TS adhesive (with isopropanol cleaner)	A 451 989 00 71
BR00.45-Z-1052-04A	Silicone remover Order no. 3295	Prosol Lacke + Farben GmbH

PARTS ORDERING NOTES

Part no.	Designation	Quantity
DG 98	BRABUS top part	1