LEMON Manuals: Even more car manuals for everyone
Home >> Smart >> 2010 >> Fortwo BRABUS, 2D Convertible >> Repair and Diagnosis >> General Information >> OEM General Information >> Overall Vehicle - FORTWO (CABRIO) (6 Of 6) >> Basic Knowledge >> Location and assignment of Z-connector sleeves (line connectors in wiring harness) in the area of the center console - GF00.19-P-3000-09MCU

Location and assignment of Z-connector sleeves (line connectors in wiring harness) in the area of the center console - GF00.19-P-3000-09MCU

Fig 1: Locating Z Connector Sleeves - Center Console
G07276793Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Z connector sleeve Designation Component Designation Connector. Pin
Z3/17  Circuit 15 (fused) connector sleeve       
← N10/10  SAM control unit  3.2 
← A1 Instrument cluster 1.14
→ B24/15 Turn rate and lateral acceleration sensor 4
→ E16 Automatic child seat recognition airbag OFF indicator lamp 1
→ N2/7 Restraint systems control unit A.2
→ N47-5 ESP control unit 28
→ N49 Steering angle sensor 4
→ N68 Steering assist control unit 3.10
→ X28/8 Driver seat ETR [GUS] connector (2-pin) 2
→ X28/9 Front passenger seat ETR [GUS] connector (2-pin) 2
→ X55/4 Front passenger seat connector block 1
Z3/44  Instrument cluster - radio circuit 15 (fused) connector sleeve       
  ← N10/10  SAM control unit  3.4 
  → A2/1 smart radio 9 A.3
  → A2/2 smart radio 10 A.3
  → N23 Heater/AC operating unit 1.5
Heated seats → N25/5 Front HS [SIH] control unit 5
  → S4/4 Right wiper switch 1.11
Convertible → S84 Power soft top switch 2
LHD → X35/1 Left door separation point C2
Z37/2  CAN engine bus (low) connector sleeve CAN       
→ A1 Instrument cluster 1.9
→ N2/7 Restraint systems control unit A.7
→ N15/5 Electronic selector lever module control unit 5
→ N23 Heater/AC operating unit 1.9
→ N49 Steering angle sensor 1
→ N88 TPM [RDK] control unit 3
→ X11/4 Data link connector 14
→ Z37/42 CAN bus (low) connector sleeve  
Z37/3  CAN engine bus (high) connector sleeve CAN       
→ A1 Instrument cluster 1.6
→ N2/7 Restraint systems control unit A.8
→ N15/5 Electronic selector lever module control unit 6
→ N23 Heater/AC operating unit 1.8
→ N49 Steering angle sensor 2
→ N88 TPM [RDK] control unit 3
→ X11/4 Data link connector 6
→ Z37/41 CAN databus (high) connector sleeve  
Z37/4  Power steering CAN bus connector sleeve (low) CAN, electric power steering       
→ A1 Instrument cluster 1.8
→ N10/10 SAM control unit 8.39
→ N68 Steering assist control unit 3.16
Z37/5  Power steering CAN bus connector sleeve (high) CAN, electric power steering       
→ A1 Instrument cluster 1.5
→ N10/10 SAM control unit 8.40
→ N68 Steering assist control unit 3.9
Z40  Stop lamp signal connector sleeve       
  ← S9/1  Stop lamp switch  2 
  → N47-5 ESP control unit 30
Not convertible (connector 1) → X18/19 Trunk lid connector 3
Convertible (connector 1) → X23/7 Soft top connector 3
Z45  ATA [EDW] sensor supply circuit 30 connector sleeve       
  ← N10/10  SAM control unit  2.1 
  → A1 Instrument cluster 1.1
  → A15x1 Additional instruments connector 1
ATA with siren → B32 Microwave sensor 2
  → B38 Rain sensor/light sensor 1
ATA with siren → H3/2 Alarm siren with inclination sensor 1
  → K52/11 Left turn signal/stop lamp relay 6
  → K52/12 Right turn signal/stop lamp relay 6
  → N15/6 Automated manual transmission control unit R.9
  → N88 TPM [RDK] control unit 1
  → S4 Combination switch 3
  → X11/4 Data link connector 16