Remove, install intake manifold pressure sensor - AR07.04-P-0100MCU

ENGINE 132.910 in MODEL 451.3 /4 

Fig 1: Identifying Intake Manifold Pressure Sensor Components

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

	Remove/install
1	Release rear drive module		AR01.00-P-3050MCU
2	Unscrew bolt (1).
3	Remove intake manifold pressure sensor (B28) from intake manifold (2) and disconnect electrical connector (3)	Installation:  Check sealing ring on intake manifold pressure sensor (B28); replace if necessary.
4	Install in the reverse order
5	Read out fault memory, erase if necessary	When replacing Intake manifold pressure sensor (B28).
	Connect STAR DIAGNOSIS and read out fault memory		AD00.00-P-2000-04MCC