Entire Combination Meter Does Not Operate [05/2014 - ]: Procedure

1. Disconnect the C50 combination meter connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   TEXT IN ILLUSTRATION
   
   

   *a	Front view of wire harness connector (to Combination Meter Assembly)

2. Measure the resistance according to the value(s) in the chart below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   C50-7 (ET) - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the chart below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   C50-6 (IG+) - Body ground	Ignition switch ON	11 to 14 V
   C50-5 (B) - Body ground	Always	11 to 14 V

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → See step   2