Customize Parameters [06/2015 - ]

CUSTOMIZE METER / GAUGE SYSTEM

Customizing with the Techstream

Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Customize Setting / Warning or Display.

Select the setting by referring to the table below.

NOTE:

Be sure to record the current value before customizing.

Warning

Tester Display	Description	Default	Setting	ECU
Key Remind Sound	Function to change the frequency of the key reminder warning buzzer	Normal	00:Normal, 01:Slow, 10:Fast	Combination meter assembly
Lane Change Flashing Times Setting	Function to change the lane change flashing times	3	000:OFF, 001:3, 010:4, 011:5, 100:6, 101:7	Combination meter assembly

Display

Tester Display	Description	Default	Setting	ECU
ECO Drive Indicator Zone	Function to change the eco driving indicator zone*	ON	0:OFF, 1:ON	Combination meter assembly
ODO Display Time After IG OFF Setting	Function to change the ODO display time after ignition switch is turned off	30s	00:30s, 01:60s, 10:600s, 11:OFF	Combination meter assembly

*: for CVT