Entire Combination Meter does not Operate [06/2015 - ]: Procedure

1. Disconnect the F32 combination meter assembly connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Front view of wire harness connector (to Combination Meter Assembly)

2. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   F32-39 (IG+) - Body ground	Ignition switch off	Below 1 V
   	Ignition switch ON	11 to 14 V
   F32-40 (B) - Body ground	Always	11 to 14 V

3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   F32-21 (ET) - Body ground	Always	Below 1 Ω

   Result

   Proceed to
   OK
   NG

Result:  1

OK 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [06/2015 - ] 

Result:  2

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR